Pianos consistently make movers annual list of products that are most regularly damaged. Grand pianos are specifically troublesome. Practicing the following procedures for taking apart, cushioning and filling grand pianos will avoid damage, lower claims expense, and improve consumer complete satisfaction.
1) A minimum of three individuals are required to manage a baby grand piano. If the baby grand piano needs to go up or down stairs or if a full or concert grand piano requires to be transported, a minimum of four people are needed.
2) Always complete a thorough and accurate inventory. It may be necessary or more effective to utilize a visual stock to effectively explain and show pre-existing damage.
3) As numerous parts are disassembled, please location all hardware in an effectively identified parts bag and then place the parts bag in a "Components Box".
4) Get rid of the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a clean furnishings pad.
5) Detach the lid by eliminating the hinge pins. Have someone wiggle the cover, holding it opposite the hinge, while a 2nd person works the pin loose. Please beware not to damage the wood with the pliers or with the pin itself. Cover the jaws of the pliers with a small fabric to help avoid damage to the wood if required. Wrap the cover in a clean furnishings pad.
6) Get rid of the prop that holds the lid open and wrap it in a tidy furniture pad. The prop has a hinge pin and is in 2 pieces.
7) Eliminate the pedal assembly and cover it in a tidy furnishings pad. When eliminating the screws, please be cautious not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the proper number on each rod.
8) Pad the piano by putting a clean rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from tumbling open while you deal with the piano. Note: Please make sure that the surface of the piano is dust-free before padding it.
9) Position a piano board and connect the straps so that it is ready to receive the piano. The raised brace on the piano board must be at the keyboard end of the piano.
10) Eliminate the left front leg by placing one individual below the piano at the left end of the keyboard. Be sure to have 2 individuals raising the corner of the piano while the third individual gets rid of the leg. Keep in mind: Please be sure to keep in mind which legs were gotten rid of from which positions since some pianos have legs that are not interchangeable.
11) Place the piano on the piano board by lowering the "leg-less" end onto the board. Please make certain to lift the entire piano slightly while finishing this maneuver to avoid excessive pressure on the staying, connected legs as the imp source piano ideas. Lift the piano to an upright position on the board. Keep in mind: Please guarantee that the soundboard is safe before lifting. Make certain that the piano is focused snugly versus the brace at the end of the piano board. Keep in mind: Never leave the piano unattended. Constantly have at least someone holding the piano consistent at all times.
12) Remove the 2 remaining legs and cover them in clean furnishings pads. These legs are held in place by a "key and slot" plan. To remove the leg, slide it inward towards the center of the piano until it comes out of the slot.
13) Protect the piano to the piano board by bringing completions of the straps together and securing them. Location folded burlap pads over the furnishings pads but under the straps to supply additional security to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, tie the loose ends of the two straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for defense against home damage, put the keyboard end of the piano towards the bottom of the stairs. Connect a hump strap to the top end of the piano board to avoid the piano from slipping.
16) To pack the piano, leave it on the piano board and location it in a tier as the very first base product with the keyboard facing the wall of the preceding tier. The best place to load the padded lid is between the Source piano and the preceding tier or between the wall and the piano.
Although grand pianos represent a significant challenge, they can be moved without damage by using sound judgment and practicing the procedures listed above.